Kippzonen Brewer MkIII Bedienungsanleitung PDF herunterladen (Seite 36)

MKIII SERVICE MANUAL

These are some of the messages seen while going into the Cosmac mode.

Motors should reset and it is ready to run the BREWER operating program type quit  to get out

of Brewcmd

To run the BREWER operating program type BREWER 

8.4 UPLOADING NEW FIRMWARE AND CONFIGURATION FILES

As KIPP & ZONEN develops new firmware and features, it is now possible for the customer to

upgrade the firmware without having to open the cover to the BREWER. The New Electronics has

incorporated Flash electrically erasable program memory and the system is capable of being

updated from the PC. The procedure below will provide a step by step process to upload the

firmware and also upload the configuration file which is erased when the new firmware is loaded.

This disk is supplied with the instrument when first delivered or will be sent out to the customer

when firmware updates are done.

Copy the new top.bin or topv#r#.bin firmware file received from KIPP & ZONEN to the

c:\bdata\nnn subdirectory.

Change to the directory c:\bdata\nnn by typing the command

cd\bdata\nnn 

Run Brewcmd.exe by typing brewcmd !

Eventually the following statement is displayed:

[using cosmac mode at 1200 baud, on com 1; tracing is off ]should be

displayed. If the command help !is entered, a list of available commands will be displayed.

Type loadmode to change modes.

Eventually the following statement is displayed:

[using loadmode at 1200 baud, on com 1: tracing is off]

Type loadmode 4800 

Eventually the following statement is displayed:

[using loadmode at 4800 baud, on com 1: tracing is off]

Type load top.bin or topv#r#.bin !!!

(# will depend on the version number of the firmware.)

Wait until this task is completed (this will take a few minutes).

The display will display some messages below:

Erasing Flash memory

Writing file top.bin to flash ……

The display will show 112 moving dots to show its progress

Turn off the power of the instrument for approximately 10 seconds and turn it back on.

Go into Opmode by typing opmode 9600 !

Waiting for mode change to complete is displayed and eventually the fan turns on if the

heater option is ordered and the display will eventually display [using operating mode at

9600 baud, on com 1: tracing is off ]

Type readlog !to display any errors encountered.

Send the configuration file to the microprocessor by typing putcfg brewnnn.cfg 

Wait a 1.5 minutes to transfer

Type readlog  to clear the log buffer and see if any errors occurred during the configuration

installation.

Type useconfig  motors should now initialize.

When complete readlog  to confirm everything is ok

8 MAIN ELEC. FIRMWARE / CONFIG. LOADING PROCEDURES

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 130 131

Kommentare zu diesen Handbüchern

Keine Kommentare

Kippzonen Brewer MkIII Bedienungsanleitung Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messgeräte Kippzonen Brewer MkIII