Kippzonen Brewer MkIII Bedienungsanleitung PDF herunterladen (Seite 132)

MKIII OPERATOR’S MANUAL

129

Motor <number>: Motor lost.

The motor controller and the instrument controller are out of step. This error will be corrected

next time the moter is moved. If this error persists for the given motor, please notify KIPP &

ZONEN <info.hol[email protected]> of the circumstances in which this message was

generated.

Motor <number>: Move attempted outside of logical bounds

An attempt was made to move the given motor out of bounds. If this error persists, please

notify KIPP & ZONEN <[email protected]> of the circumstances in which this

message was generated.

Motor <number>: Movement attempted with too large a jerk

Please notify KIPP & ZONEN <info.holland@kippzonen.com> of the circumstances in which

this message was generated.

Motor <number>: Movement attempted with too large an acceleration

Please notify KIPP & ZONEN <info.holland@kippzonen.com> of the circumstances in which

this message was generated.

Motor <number>: Movement attempted with too large a velocity

If this error persists for the given motor, please notify KIPP & ZONEN

<info.holl[email protected]> of the circumstances in which this message was generated.

Motor <number>: time allotted (<ss> seconds) for motor movement has expired. Motor

stopped.

The value <ss> comes from the MOTOR.TIME.OUT configuration parameter.

New value set for watermark <nameOfWatermark>: <latestMark> <unitsOfWatermark>.

The indicated watermark value has been changed to <latestMark>. The possible watermarks

are identified in Appendix H.

No Flash config segment in Flash to copy into RAM upon initialization

Attempt to initialize when no configuration information had been loaded yet. This message is

normal as part of the process of loading new firmware.

Parallel command operation not supported:

A command was issued which requested that two operations run in parallel when that is not

legal. The subsequent two messages indicate that the command is bad and present the

command. The following commands cannot start while another command is still in operation:

I, PMT, R, SAVE, STEPS, USECONFIG

PMT counter failure

The two independent counters on the PMT did not match count rates (differed by more than

2).Counter 2 has been disabled until explicitly re-enabled or until the instrument reinitializes.

APPENDIX I FIRMWARE LOG

1 2 ... 127 128 129 130 131 132 133 134 135 136

Keine Kommentare

Kippzonen Brewer MkIII Bedienungsanleitung Seite 132